Full-Repair.comI'm sorry for not perfect english. In time I'll do a good quality translate. If you could not get anything please feel free to contact me in comments. I will answer you as soon as possible.
Hit me navigator Texet TN-606 with a cracked screen.
To replace it, you must first find what I started.
So right screen could not be found. It was possible only after an analysis to find the letters that are written in a line: «8T000291-00 J & T in 1013."
To this navigator is the screen «AT050TN33». This is a five-inch LCD screen with touch (size 120h75 mm, 40-pin in a line). Also this screen is suitable for a range of other GPS-navigators:
- BBK N5026
- Explay PN-980
- Explay PN-930
- Explay PN-935
- Pioneer PM-930
- Prestigio Geovision 5500
- Prestigio Geovision 5200 BT
- Prology iMap 524Ti
- Texet TN-700
- Texet TN-705
- Texet TN-710
- Texet TN-606
- Texet TN-610
- Texet TN-700
proceed to replacing the screen
First, take out the battery, memory card and SIM.
There are no screws holding the case does not, so just otkovyrivaem body.
After removing the housing unplug the ribbon display on the motherboard.
You can remove the screen, it is based on three latches.
If broken down and touch and LCD screens, simply insert a new module and collect. Done!
Replacement Touch Screen
If only the touch screen is broken, and the LCD module correctly showed the picture is slightly more complicated.
Sealed-off FOUR train.
Gently touch screen were peeled off from the metal housing of the LCD screen.
It remains to glue the new touch screen and solder the cable, and then assemble the unit.
